Only for commercial customers.
- Similar in technology to the TonerVac from 3M, but ca. 6 dB(A) less noisy(!), and consumes less energy
- 2 filter types: Type 1 is a HEPA filter for very fine toner, type 2 is for normal toner
- one filter type 2 included
- with overheat-protection
- ESD-safe
- 230V motor with 450 W
- ca. 49 x 23.5 x 19 cm (LxHxW), weight ca. 5 kg
Note: this vacuum cleaner is meant to clean toner pollution in printers and copiers. If big toner quantities must be cleaned, e.g. if cartridges are opened, other vacuum cleaners with atex-certification may be required. If in doubt, please refer to the toner material safety data sheet.
WEEE-Reg.-Nr. DE20337627.
Part list
Features:
- Reduced maintenance effort through long-term or for-life lubrication
- reliable function with many years of application experience
- Versatile use even with higher loads
- Low starting and running torque, especially at low temperatures, enables high efficiency and therefore energy savings
- Increased component lifespan thanks to good wear protection
- Temperature range: -50 to +130°C
Contents: 50g tube
Elastic tips: dimensionally stable even when twisted. Distortion-tolerant, elastic precision tips. Half-round, long, tapered jaws. With cutting edges for soft, medium-hard and hard wire. Cutting edges additionally induction-hardened, cutting edge hardness approx. 61 HRC. straight jaws.
Dreusicke
Areas of application:
- Service and maintenance area
- Automotive and aviation industry
- Electrical industry
- Medical areas
Features:
- polyester reinforced pulp
- absorbs fats and liquids very well
- super strong, both dry and wet
- very dense structure
- lint-free
- colorfast and solvent resistant
- heat-resistant up to 230 °C
- FCC (Food Safety Certificate)
Part list
slotted: 1.2x6.5mm
Hex-Plus: 2.0 - 2.5 - 3.0 - 4.0 - 5.0 - 6.0
Phillips: PH1 - PH2 - PH3
Pozidriv: PZ1 - PZ2 - PZ3
Spanner: 4 - 6 - 8
Torx-Plus: TX8 - TX10 - TX15 - TX20 - TX25 - TX27 - TX30 - TX40
Torq-Set Mplus: 6 - 8 - 10
Tri-Wing: 1 - 2 - 3 - 4