Dreusicke offers the fine tools you will need for the maintenance and repair of office machines, computers, electronic and/or fine-mechanical devices. (for commercial users only)
Part list
Profit
Diamond drill bits for granite, hard stone, tiles and porcelain stoneware - depth of cut 35 mm
- from 18 mm equipped with Click & Drill system
- no angle grinder required, just a drill
- precise positioning, center drill prevents slipping
- No cooling water required, therefore less dirt
The Diamond Dry Hole Saw is a very versatile tool that can be used in a wide variety of designs for a wide variety of materials. In order to extend the service life of this hole saw and to determine the optimal speed and thus achieve optimal drilling results, the hole saws must be used correctly. It is not only the right hole saw that is important for the relevant material, but also the right speed. Too high or too low speeds when drilling the corresponding material can lead to excessive wear and poor drilling results. In this case, the teeth "slip" over the material and no longer grip properly. Here is an overview of the guide values
Technical data:
- Raw material: LDPE
- Thickness 0.2 mm = 200 mµ
- Density: approx. 0.9 g / cm³ - Tensile strength: approx. 10-25 N / mm² - Melting point: approx. 110 ° C - Temperature resistance: approx. -40 ° C / + 80 ° C
- Under tolerance: 30% +/- 5%
Part list
Special price til 31.03.2015, then again EUR 58,70!!
Part list
Part list
Kstools
- FlankTraction profile
- based on DIN 3113 / ISO 3318
- Jaw position angled at 15°
- Ring angled 15°
- with switch lever
- precisely toothed with 72 teeth
- very fine satin finish
- Chrome vanadium