Dreusicke offers the fine tools you will need for the maintenance and repair of office machines, computers, electronic and/or fine-mechanical devices. (for commercial users only)
Knipex
Cutting (Ø mm): soft 4,8/ medium hard 3,8/ hard 2,7 und piano 2,2. With polished head. 160 mm OAL.
- TRUE RMS voltage measurement (1000 V)
- TRUE RMS current measurement (10 A, 20 A for 30 s.)
- Resistance measurement (60 M )
- Capacitance measurement (10 mF)
- Frequency measurement (mains and logic levels)
- Duty cycle measurement (%)
- 4 mA - 20 mA current loop measurement (%)
- Temperature measurement (°C)
- Fast continuity test (< 100 s) with optical and acoustic display
- Diode test
- VoltSensor function (non-contact and single-pole phase test (2 levels of sensitivity))
Features:
- Backlit digital display with 60,000 digit resolution
- TRUE RMS true RMS measurement (AC and AC+DC) for measuring non-linear signals
- MIN/ MAX/ AVERAGE and fast PEAK recording (250 s)
- Socket control (optical/acoustic) in the A/mA and A range with warning in the event of incorrect operation (fuse protection)
- AutoV function for automatic AC/DC switching and measuring range selection
- Low-pass filter (HFR high-frequency rejection, 1000 Hz) for measurements on clocked motor drives
- Display HOLD and Auto-HOLD when the measured value is stable
- Ergonomic 2-component housing for increased grip and shock resistance
Scope of delivery:
- Digital multimeter with integrated protective rubber frame for increased grip and shock resistance, rear stand and test lead holder Protective case
- High-quality silicone test leads with gold-plated 2 mm and screw-on 4 mm test tips
- Wire temperature sensor
- Batteries (3 x 1.5 V Micro AAA/ IEC LR03)
Part list
Wera
Knipex
- sturdy, zero-backlash box joint
- low-friction double spring for gentle and even opening
- the finish together with a fine film of oil offer effective rust protection no circuit faults caused by peeling chrome from plated tools
- cutting edges additionally induction hardened, cutting edge hardness approx. 62 HRC
- High-grade special tool steel, forged, oil-hardened
- max. cutting rates: soft 0,3 - 1,6 / medium hard 1,2 / hard 0,6 mm
- round head, polished, with bevel
- handles plastic coated
- length approx. 115mm, weight approx. 67gr
